Enum sp_std::sync::mpsc::TrySendError

pub enum TrySendError<T> {
    Full(T),
    Disconnected(T),
}

This enumeration is the list of the possible error outcomes for the try_send method.

Variants

Full(T)

The data could not be sent on the sync_channel because it would require that the callee block to send the data.

If this is a buffered channel, then the buffer is full at this time. If this is not a buffered channel, then there is no Receiver available to acquire the data.

Disconnected(T)

This sync_channel’s receiving half has disconnected, so the data could not be sent. The data is returned back to the callee in this case.

Trait Implementations

impl<T> Clone for TrySendError<T>where T: Clone,

fn clone(&self) -> TrySendError<T>

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl<T> Debug for TrySendError<T>

fn fmt(&self, f: &mut Formatter<'_>) -> Result<(), Error>

Formats the value using the given formatter.

impl<T> Display for TrySendError<T>

fn fmt(&self, f: &mut Formatter<'_>) -> Result<(), Error>

Formats the value using the given formatter.

impl<T> Error for TrySendError<T>

fn description(&self) -> &str

👎Deprecated since 1.42.0: use the Display impl or to_string()

fn source(&self) -> Option<&(dyn Error + 'static)>

The lower-level source of this error, if any.

fn cause(&self) -> Option<&dyn Error>

👎Deprecated since 1.33.0: replaced by Error::source, which can support downcasting

fn provide<'a>(&'a self, demand: &mut Demand<'a>)

🔬This is a nightly-only experimental API. (error_generic_member_access)

Provides type based access to context intended for error reports.

impl<T> From<SendError<T>> for TrySendError<T>

fn from(err: SendError<T>) -> TrySendError<T>

Converts a SendError<T> into a TrySendError<T>.

This conversion always returns a TrySendError::Disconnected containing the data in the SendError<T>.

No data is allocated on the heap.

impl<T> PartialEq<TrySendError<T>> for TrySendError<T>where T: PartialEq<T>,

fn eq(&self, other: &TrySendError<T>) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl<T> Copy for TrySendError<T>where T: Copy,

impl<T> Eq for TrySendError<T>where T: Eq,

impl<T> StructuralEq for TrySendError<T>

impl<T> StructuralPartialEq for TrySendError<T>